Treadmill Motor Belt

Owning a treadmill is not just a walk in your bedroom!

It is outstanding to have a treadmill in your own home for a good deal of reasons, but one of the downfalls is the fact that you are solely responsible for the maintenance and upkeep of this costly piece of equipment. This article will aid you carry out the most widely preformed service by treadmill technicians, measuring and altering a treadmill belt.

Many will find that they need to replace the treadmill belt when there are visible signs of fraying or turning up on the edges. When these signs are evident action ought to be taken speedily so as not to harm the treadmill deck.

How to Measure and Determine the Belt Size

The original step is to determine the brand and model number, if you have a well known brand you will find that there are some companies that will likely accommodate your brand, but if you own a lesser recognise brand you may need to particular order the belt.

When the model and brand are known, the next step is to measure as accurately as possible so that you may get the proper belt the introductory time around. To measure the belt you may either cut the belt altogether off or take a tape measure or piece of string or go totally around the entire belt. If the belt is totally cut off do not forget to take into contemplation that there may be stretching.

After measuring the entire length of the belt, you will have to then measure the width of the belt. At this time you have the belt size and are ready to order from your chosen source.

How to Replace a Treadmill Belt

When the belt arrives get started with unplugging the treadmill at the power source. When this is finished you will then need to locate and remove the motor hood. When the hood is exclusively removed, locate the screws that adjust the belt tension. (Generally on the rear or sides of the back of treadmill). Then loosen the both sides and push the rear roller forward or toward the deck. Now loosen and remove the front roller. Tip if the treadmill inclines you may turn on the power and more or less incline tread deck so that the roller is effortlessly removed. When front roller is removed, repeat on the rear roller.

The sides of the treadmill have screws that hold the deck securely in place. You will need to remove these screws and then lift the deck and belt out at the same time.

When the deck and belt are separated, the deck will need to be wax or lubricated (whichever is conveyed by your users manual).

Most belts will indicate on the inside on the belt which direction the belt ought to move, if not observe that there is in all likelihood a visible seam that travels downward from left to right.

When the proper direction is determined, you are ready to slide the belt onto the deck, making sure that the belt is decently aligned. The deck then is ready to be placed back onto the treadmill and the screws may then are started, but wait to tighten completely.

Once the screws are started you may then pull the treadmill away from the deck and slide in the rear roller. At this time, begin screw sufficient to hold but not to tighten. Now repeat on the front roller. Replace the drive motor belt over the drive gear, doing this prior to tighten the rollers. When the front roller feels secure, repeat on the rear roller with the adjusting screws. Take care to tighten each side evenly until the belt feels secure on the deck.

Turn the treadmill on, and take detect to see if the belt starts moving, and cautiously get onto the treadmill keeping on the handrails. If the belt stops moving when you step onto it, adjustment is needed. To adjust, step off the treadmill and tighten each screw one full turn. If this does not solve the problem proceed repeating this step until the belt does not stop when walking on the belt.

When the belt does not stop when being used, you then will want to put heavy pressure and increase speed (all the while keeping onto the hand rails). If you obtain a problem while repeating this process, you will need further and added adjustments. Repeat these processes until you are satisfied with the belt placement and tension.

Always do not forget that if you are not comfortable with this process, please contact a treadmill professional.

Treadmill Motor Belt Image

Treadmill Motor Belt Pic

Treadmill Motor Belt Photo